Loading ...
Loading ...
Loading ...
Effect parameters |569
f Tap3 Level 0…100 Sets the Tap3 output level
Pan L, 1…99, R Sets the stereo image of tap3
FB Amt –100…+100 Sets the Tap3 feedback amount
g Feedback 0…100 Sets the amount of feedback for Taps 1, 2, and 3
Src Off…Tempo Selects the modulation source of feedback
amount
Amt –100…+100 Sets the feedback amount
h High Damp [%] 0…100 Sets the damping amount in the high range
Low Damp [%] 0…100 Sets the damping amount in the low range
i Saturation 0…100 Sets the distortion amount
j Input Trim 0…100 Sets the input gain
Pre Tone 0…100 Sets the tone of the input
k Wow Flutter [Hz] 0.02…1.00 Sets the frequency at which pitch variation will
occur
Wow Flutter depth 0…100 Sets the depth of pitch variation
l Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See the list of DMS (Dynamic Modulation Sources)
at the beginning of this part
Amt –100…+100 Amount of modulation source
a: Delay (Tap1) [msec]
a: Src
a: Amt
b: Tap2 Position [%]
b: Tap3 Position [%]
The delay time for Tap 2 and 3 is specified as a proportion (%) relative to
“Delay (Tap1).” Even if you use dynamic modulation to control “Delay (Tap1),”
Tap 2 and 3 will change at the same proportion.
d: FB Amt
e: FB Amt
f: FB Amt
g: Feedback
The feedback output from Tap 1, 2, and 3 is mixed according to the “FB Amt,”
and then the final amount of feedback is specified by “Feedback.”
Loading ...
Loading ...
Loading ...