Loading ...
Loading ...
Loading ...
676| Effects for the Sounds, Voice, Guitar
d: Pre Low-cut
Cutting the signal in the low range before it is input to the Distortion will cre-
ate a sharp distortion.
d: Drive
e: Output Level
The degree of distortion is determined by the level of input signal and the
setting of “Drive”. Raising the “Drive” setting will cause the entire volume
level to increase. Use the “Output Level” parameter to adjust the volume
level. The “Output Level” parameter uses the signal level input to the 3-Band
EQ. If clipping occurs at the 3-Band EQ, adjust the “Output Level” parameter.
OD/HyperGain Wah (Overdrive/Hyper Gain Wah)
This distortion effect has two modes: overdrive and hyper-gain that produc-
es a strong distortion. A higher high-gain setting is required for this effect
relative to a normal-size effect.
Left
Right
FX Amt
FX Amt
FX Amt = 100: Mono In - Mono Out / FX Amt = 0: Stereo In - Stereo Out
Amp Simulation
3 Band EQ
Output Level
Direct Mix
Pre Low-cut
D
-mod
Wah
Mode: Overdrive / Hyper-Gain
Drive
Driver
+
a Wah Off, On Switches Wah on/off
Src Off…Tempo Selects the modulation source that
switches the Wah on and off
Sw Toggle, Moment Selects the switching mode for the
modulation source that switches the
Wah on and off
b Wah Sweep Range –10…+10 Sets the range of Wah
Wah Sweep Src Off…Tempo Selects the modulation source that
controls the Wah
c Drive Mode Overdrive, Hyper-Gain Switches between overdrive and hi-
gain distortion
Loading ...
Loading ...
Loading ...