Loading ...
Loading ...
Loading ...
598| Effects for the Sounds, Voice, Guitar
Classic Chorus
This models a famous chorus unit that was built into a guitar amp. Although
it does not provide a chorus and vibrato select switch, you can use the “Wet/
Dry” and “Bus” settings to produce their effect. The “Speed,” “Depth,” and
“Manual” parameters allow an even wider range of sounds than the original
unit.
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
+
Chorus
LFO
Output Mode
Mono
Stereo
(L-D&R-W)
a Speed [Hz] 0.10…10.0 Sets the LFO speed
Src Off…Tempo Modulation for the chorus speed. See the list of
DMS (Dynamic Modulation Sources) at the begin-
ning of this part
Amt –10.00…
+10.00
Sets the modulation amount of the chorus speed
b Depth 1…100 Sets the depth of LFO modulation
Src Off…Tempo Modulation for the chorus depth. See the list of
DMS (Dynamic Modulation Sources) at the begin-
ning of this part
Amt –100 … +100 Sets the modulation amount of the chorus depth
c Manual 0…99 Sets the delay time for chorus. If Depth is set to
100, Manual will not function.
d Output Mode Mono, Stereo
( L- D r y & R - W e t )
The output mode switches between vibrato and
chorus. Mono is a vibrato, Stereo is a chorus.
e Wet/Dry Dry, 1:99 … 99:1, Wet Balance between the wet and dry signal
Src Off…Tempo Selects a modulation source for Wet/Dry
Amount –100 … +100 Sets the modulation amount for Wet/Dry
Loading ...
Loading ...
Loading ...