Loading ...
Loading ...
Loading ...
88
5. CLI Commands
show name
Use the show name command to display the name entered for the sensor.
Syntax
show name
Examples
The following command displays the specified sensor’s name:
console> device (PDU123)> sensor (Temp1)> show name
Temp1
device: sensor: output
output
Use the output command to configure the output contacts of an E2MTDO sensor.
Syntax
output {contact-1 | contact-2} alarm-level {normally_open | normally_closed}
output {contact-1 | contact-2} description <value>
• value – Specifies a description for the output contact.
no input {contact-1 | contact-2} description <value>
• value – Clears the description for the output contact.
Example
The following command sets “normally_open” as the contact-1 alarm level for sensor “E2MTDO-456” connected to device
“PDU-Rack1”:
console> device (PDU-Rack1)> sensor (E2MTDO-456)> output contact-1 alarm-level
normally_open
Update complete
The following command sets “Beacon 12-A” as the contact-2 description for sensor “E2MTDO-456” connected to device
“PDU-Rack1”:
console> device (PDU-Rack1)> sensor (E2MTDO-456)> output contact-2 description “Beacon 12-A”
Update complete
output close
Use the output close command to close an output contact of an E2MTDO sensor. On executing this command, a confirmation
message will appear; use the force option to close the contact without confirmation.
Syntax
output {contact-1 | contact-2} close [force]
Example
The following command closes contact-1 of sensor “E2MTDO-456” connected to device “PDU-Rack1”:
console> device (PDU-Rack1)> sensor (E2MTDO-456)> output contact-1 close
Are you sure? Type “yes” to proceed:
Loading ...
Loading ...
Loading ...