Loading ...
Loading ...
Loading ...
64
5. CLI Commands
device: load: ramp
ramp delay
Use the ramp delay command to set the time that the specified load must wait before it turns on. This command requires the
load to be enabled for a ramp function via the ramp enable command. Note that on exiting the load (<load-num>) format,
the apply ramp-shed command must be used for the changes to take effect.
Syntax
ramp delay <delay-time>
• delay-time – Specifies the ramp delay time, in seconds, for the specified load.
Examples
The following command sets the ramp delay time for load #2 to 30 seconds, on device “PDU-Rack1”:
console> device (PDU-Rack1)> load (2)> ramp delay 30
Update complete
ramp enable
Use the ramp enable command to turn on a specified load when a ramp is initiated. This command applies to devices that
support controllable loads. Use the no form of this command to have a load remain in its present state during a ramp. Note
that on exiting the load (<load-num>) format, the apply ramp-shed command must be used for the changes to take effect.
Syntax
ramp enable
no ramp enable
Examples
The following command enables the ramp function for load #2 on device “PDU-Rack1”:
console> device (PDU-Rack1)> load (2)> ramp enable
Update complete
show ramp
Use the show ramp command to display the ramp details for the load.
Syntax
show ramp [delay | enable]
Examples
The following command displays the ramp details for load #2 on device “PDU-Rack1”:
console> device (PDU-Rack1)> load (2)> show ramp
Ramp Delay : 30
Ramp Status : enabled
Loading ...
Loading ...
Loading ...