Loading ...
Loading ...
Loading ...
113
5. CLI Commands
show https
Use the show https command to display the current settings for the HTTPS service.
Syntax
show https [status | port]
Examples
The following command displays all HTTPS service information:
console> show https
HTTPS Status : disabled
HTTPS Port : 4033
ipv4
ipv4 enable
Use the ipv4 enable command to enable the IPv4 service. Use the no form of this command to disable the service. Note that
changes to network parameters must be applied using the apply network command for the changes to take effect. The IPv4
service is enabled by default. To check current network settings, use the show network command.
Syntax
ipv4 enable
no ipv4 enable
Examples
The following command enables the IPv4 service:
console> ipv4 enable
Update complete
NOTE: Use the “apply network” command to complete the change. This may cause a system
reboot.
ipv4 address
Use the ipv4 address command to configure the IPv4 settings. The default setting for IPv4 address is DHCP.
Syntax
ipv4 address dhcp
ipv4 address <address> {</prefix-length> | <mask>} [gateway < gateway-address>]
• gateway-address – Specifies the IPv4 address for the gateway.
• ipv4-address – Specifies the static IPv4 address to assign to the system.
• mask - Specifies the subnet mask IP address.
• prefix-length – Specifies the number of bits comprising the IPv4 address prefix (Range: 1-30). The value must be preceded
by a forward slash character (/).
continued
Loading ...
Loading ...
Loading ...