Loading ...
Loading ...
Loading ...
Remote Control Commands
R&S
®
RTB2000
419User Manual 1333.1611.02 ─ 03
●
CHANnel<m>:THReshold on page 256
In all BUS<b>:LIN... commands, the suffix <b> selects the bus.
BUS<b>:LIN:DATA:SOURce...........................................................................................419
BUS<b>:LIN:POLarity.....................................................................................................419
BUS<b>:LIN:STANdard..................................................................................................419
BUS<b>:LIN:BITRate..................................................................................................... 419
BUS<b>:LIN:DATA:SOURce <Source>
Sets the source of the data line. All channel waveforms can be used.
Suffix:
<b>
.
1 | 2
Parameters:
<Source> CH1 | CH2 | CH3 | CH4 | D0..D15
*RST: CH1
BUS<b>:LIN:POLarity <Polarity>
Defines the idle state of the bus. The idle state is the recessive state and corresponds
to a logic 1.
Suffix:
<b>
.
1 | 2
Parameters:
<Polarity> IDLHigh | IDLLow
IDLHigh: Low active, negative polarity
IDLLow: High active, positive polarity
*RST: IDLL
BUS<b>:LIN:STANdard <Standard>
Selects the version of the LIN standard that is used in the DUT. The setting mainly
defines the checksum version used during decoding.
The most common version is LIN 2.x. For mixed networks, or if the standard is
unknown, set the LIN standard to AUTO.
Suffix:
<b>
.
1 | 2
Parameters:
<Standard> V1X | V2X | J2602 | AUTO
*RST: V1X
BUS<b>:LIN:BITRate <BitRate>
Sets the number of transmitted bits per second.
Serial Bus Analysis
Loading ...
Loading ...
Loading ...