Loading ...
Loading ...
Loading ...
Measurements
R&S
®
RTB2000
106User Manual 1333.1611.02 ─ 03
Meas. Place
Selects one of the four available measurement places to be configured or activated.
Measure <n>
Activates or deactivates the selected measurement.
Remote command:
MEASurement<m>[:ENABle] on page 307
Type
Defines the measurement type to be performed on the selected source. Depending on
the type, different results are displayed in the result line.
Select the tab of the required measurement category, and then the measurement type.
The "Basic" tab provides the most common measurements: peak to peak, period, fre-
quency, rise time, fall time, mean cycle, and RMS cycle.
Remote command:
MEASurement<m>:MAIN on page 307
Source
Selects an analog channel, reference or math waveform as the source of the selected
measurement. If MSO option R&S RTB-B1 is installed, active digital channels are
available as measurement sources.
If the waveform is not active, it is activated automatically when selected as measure-
ment source.
Remote command:
MEASurement<m>:SOURce on page 309
Measure Source, Reference Source
Set the source waveforms for delay and phase measurement, where two sources are
required.
Remote command:
MEASurement<m>:SOURce on page 309
Delay Setup: Measure Source and Reference Source
Set the edges to be used for delay measurement. You can measure the delay between
two rising edges, two falling edges, between rising and next falling edge, and vice
versa.
Remote command:
MEASurement<m>:DELay:SLOPe on page 310
Statistics
Activates or deactivates the statistical evaluation for the selected measurement.
Remote command:
MEASurement<m>:STATistics[:ENABle] on page 310
Reset Statistics
Deletes the statistical results for all measurements, and starts a new statistical evalua-
tion if the acquisition is running.
Automatic Measurements
Loading ...
Loading ...
Loading ...