Loading ...
Loading ...
Loading ...
Remote Control Commands
R&S
®
RTB2000
240User Manual 1333.1611.02 ─ 03
15 Remote Control Commands
This chapter provides the description of all remote commands available for
R&S RTB2000. The commands are sorted according to the menu structure of the
instrument. A list of commands in alphabetical order ist given in the "List of Com-
mands" at the end of this documentation.
Processing of remote control commands
The response time on remote commands depends on several factors:
●
Number of active channels
●
Number of active measurements
●
Size of the acquisition memory
●
Timebase
●
Trigger frequency
The R&S RTB2000 processes measurement queries in the following way:
●
In stop mode or with slow trigger frequency if no new data since last value calcula-
tion is available, the oscilloscope sends the measured value in the response.
●
Otherwise, if new data since last value calculation is available, the oscilloscope cal-
culates and sends the response.
●
Conventions used in Command Description.........................................................240
●
Programming Examples........................................................................................241
●
Common Commands............................................................................................ 247
●
Waveform Setup................................................................................................... 250
●
Trigger...................................................................................................................266
●
Waveform Analysis............................................................................................... 276
●
Measurements...................................................................................................... 306
●
Applications...........................................................................................................323
●
Documenting Results............................................................................................338
●
General Instrument Setup.....................................................................................359
●
Serial Bus Analysis............................................................................................... 370
●
Mixed Signal Option (Option R&S RTB-B1)..........................................................431
●
Signal Generation (Option R&S RTB-B6)............................................................. 442
●
Status Reporting................................................................................................... 454
15.1 Conventions used in Command Description
Note the following conventions used in the remote command descriptions:
●
Command usage
If not specified otherwise, commands can be used both for setting and for querying
parameters.
If a command can be used for setting or querying only, or if it initiates an event, the
usage is stated explicitly.
●
Parameter usage
Conventions used in Command Description
Loading ...
Loading ...
Loading ...