Loading ...
Loading ...
Loading ...
Serial Bus Analysis
R&S
®
RTB2000
169User Manual 1333.1611.02 ─ 03
Label
Displays or hides the bus label. The bus label is shown on the right side of the display
at the bus signal, and in the bus table. The bus and its label are only visible, if
"Decode" is enabled.
You can enter a label text in several ways:
●
Select a string from the library list at "Predefined Label".
●
Enter a user-defined text using "Edit Label".
Remote command:
BUS<b>:LABel:STATe on page 372
Predefined Label
Selects a bus label from the following list:
●
SPI
●
SSPI
●
I2C
●
UART
●
CAN
●
LIN
●
PARALLEL
●
ADDRESS
●
DATA
●
RS232
Edit Label
Enter a user-defined name for the bus. The maximum name length is 8 characters.
You can use only ASCII characters provided on the on-screen keyboard.
Remote command:
BUS<b>:LABel on page 371
12.1.5 Label List
For all protocols using ID or address identification, it is possible to create label lists
containing addresses or IDs, a symbolic name for each node (symbolic label), and
some protocol-specific information.
You can load label lists, and activate its usage for decoding. As a result, the decoded
signal shows the symbolic label instead of the ID or address values, so it is easy to
identify the messages of the different bus nodes.
Basics of Protocol Analysis
Loading ...
Loading ...
Loading ...