Loading ...
Loading ...
Loading ...
Applications
R&S
®
RTB2000
118User Manual 1333.1611.02 ─ 03
Load Mask
Opens a file explorer to select a previously stored mask. The selected mask is loaded
and can be used for a subsequent test.
Remote command:
MASK:LOAD on page 324
Actions
Opens a submenu to select the actions to be taken when a violation against the mask
limits occurs.
"Sound"
Generates a beep sound at each violation.
"Stop"
Stops the waveform acquisition. Set the number of the stop violation.
Thus, you can ignore a number of violations before stop.
"Pulse"
Creates a pulse on the AUX OUT connector. This selection sets the
configuration of the AUX OUT connector to "Mask Violation".
"Screenshot"
Saves a screenshot according to the settings in "File" > "Screen-
shots".
"Save Wave-
form"
Saves the waveform data according to the settings in "File" > "Wave-
forms".
Remote command:
MASK:ACTion:SOUNd:EVENt:MODE on page 325
MASK:ACTion:STOP:EVENt:MODE on page 325
MASK:ACTion:STOP:EVENt:COUNt on page 325
MASK:ACTion:PULSe:EVENt:MODE on page 325
MASK:ACTion:SCRSave:EVENt:MODE on page 325
MASK:ACTion:WFMSave:EVENt:MODE on page 325
8.2 FFT Analysis
The R&S RTB2000 provides basic FFT calculation, which is included in the firmware.
► To enable the FFT analysis, press the FFT key.
Short menu for FFT
To select which type of waveforms are displayed in the FFT diagram, you can use the
FFT short menu. Also you can set a full span and disable the FFT analysis.
► To open the short menu for an FFT, tap the FFT label in the bottom line of the dis-
play. The label is only available, if the FFT analysis is enabled.
FFT Analysis
Loading ...
Loading ...
Loading ...