Loading ...
Loading ...
Loading ...
Signal Generation (Option R&S RTB-B6)
R&S
®
RTB2000
235User Manual 1333.1611.02 ─ 03
Remote command:
PGENerator:PATTern:STATe on page 449
Pattern
Selects the pattern type.
"Square Wave"
Generates a square wave pattern at pin P0.
"Counter"
Generates a 4-bit wide counter pattern at pins P0 to P3.
"Arbitrary"
Creates, saves or loads an arbitrary 4-bit wide pattern and outputs it
at pins P0 to P3.
"Manual"
Sets the high or low state for each pin.
"UART, SPI,
I2C, CAN, LIN"
Generates a bus signal for measurements without measurement
object.
Remote command:
PGENerator:FUNCtion on page 449
14.2.2 Settings for Square Wave Pattern
Frequency
Sets the frequency of the square wave.
The values of the "Frequency" and "Period" depend on each other, as:
Period = 1/ Frequency
If you change the value, the "Period" is adjusted accordingly.
Remote command:
PGENerator:PATTern:FREQuency on page 450
Period
Sets the period of the square wave. If you change the value, the "Frequency" is adjus-
ted accordingly.
Remote command:
PGENerator:PATTern:PERiod on page 450
Polarity
Sets normal or inverted polarity.
Remote command:
PGENerator:PATTern:SQUarewave:POLarity on page 453
Duty Cycle
Sets the duty cycle of the square wave from 1% to 99%.The duty cycle expresses for
what percentage of the period, the signal state is high.
Remote command:
PGENerator:PATTern:SQUarewave:DCYCle on page 453
Pattern Generator
Loading ...
Loading ...
Loading ...