Loading ...
Loading ...
Loading ...
Remote Control Commands
R&S
®
RTB2000
269User Manual 1333.1611.02 ─ 03
TRIGger:A:EDGE:COUPling <Coupling>
Sets the coupling for the trigger source.
Parameters:
<Coupling> DC | AC | LFReject
DC
Direct current coupling. The trigger signal remains unchanged.
AC
Alternating current coupling. A highpass filter removes the DC
offset voltage from the trigger signal.
LFReject
Sets the trigger coupling to high frequency. A 15 kHz highpass
filter removes lower frequencies from the trigger signal. Use this
mode only with very high frequency signals.
*RST: DC
TRIGger:A:EDGE:FILTer:HFReject <State>
Enables or disables an additional 5 kHz lowpass filter in the trigger path. This filter
removes higher frequencies and is available with AC and DC coupling.
To folter out higher frequencies, you can use either this command or
TRIGger:A:
EDGE:FILTer:NREJect
.
Parameters:
<State> ON | OFF
*RST: OFF
TRIGger:A:EDGE:FILTer:NREJect <State>
Turns an additional 100 MHz lowpass filter in the trigger path on or off. This filter
removes higher frequencies and is available with AC and DC coupling.
To folter out higher frequencies, you can use either this command or
TRIGger:A:
EDGE:FILTer:HFReject
.
Parameters:
<State> ON | OFF
*RST: OFF
15.5.3 Width Trigger
To set the trigger level (threshold), use:
●
TRIGger:A:LEVel<n>[:VALue] on page 268
CHANnel<m>:THReshold on page 256
●
TRIGger:A:FINDlevel on page 268
CHANnel<m>:THReshold:FINDlevel on page 256
Trigger
Loading ...
Loading ...
Loading ...