Loading ...
Loading ...
Loading ...
Serial Bus Analysis
R&S
®
RTB2000
170User Manual 1333.1611.02 ─ 03
You can also also use the label list to trigger on an identifier or address. Instead of
entering the value, you select the name, which is defined in the label list.
The format of label list files is PTT.
Label lists are protocol-specific. They are described in the corresponding protocol
chapters:
●
Chapter 12.5.5, "CAN Label List", on page 205
●
Chapter 12.6.6, "LIN Label List", on page 217
12.1.5.1 Using Label Lists
To load a label list and display the labels
1. Save the label list file on a USB flash drive.
2. Press the PROTOCOL key.
3. Configure the protocol.
4. In the "Bus" menu, select "Label List".
5. Select "Load".
6. Navigate to the label list file, select it, and tap "Load".
7. To read the label list, tap "Show Label List".
8. To see the node labels in the display of the decoded data, tap "Apply".
To trigger on an identifier or address using the label
Prerequisites: The bus is configured, decoding is enabled, and a decoded signal is visi-
ble.
1. Open the "Bus" menu.
2. Select "Trigger".
3. Set the following trigger settings:
Basics of Protocol Analysis
Loading ...
Loading ...
Loading ...