Loading ...
Loading ...
Loading ...
Logic Analyzer (Option R&S RTB-B1, MSO)
R&S
®
RTB2000
225User Manual 1333.1611.02 ─ 03
Figure 13-2: Configuration menu Parallel clocked bus
The menus offer the following settings:
Bus Width....................................................................................................................225
Thresholds.................................................................................................................. 225
Source.........................................................................................................................225
Set to Default.............................................................................................................. 226
Chip Select..................................................................................................................226
Polarity........................................................................................................................ 226
Slope...........................................................................................................................226
Bus Width
Sets the number of lines (bits) of the logic channels D0 to D15 to be analyzed in the
parallel or clocked parallel bus. The maximum number is the number of logic input
lines.
Remote command:
BUS<b>:PARallel:WIDTh on page 437
BUS<b>:CPARallel:WIDTh on page 438
Thresholds
Separately sets the thresholds for the source lines D0 to D7 and for the source lines
D8 to D15 of the parallel or clocked parallel bus.
Remote command:
LOGic<p>:THReshold:UDLevel on page 435
Source
Selects the input line for each bit of the parallel or clocked parallel bus.
If you use a clocked parallel bus, in the last two lines you can select the source for the
"Clock" and "CS".
Remote command:
BUS<b>:PARallel:DATA<m>:SOURce on page 438
BUS<b>:CPARallel:DATA<m>:SOURce on page 438
Parallel Buses
Loading ...
Loading ...
Loading ...