Loading ...
Loading ...
Loading ...
Serial Bus Analysis
R&S
®
RTB2000
167User Manual 1333.1611.02 ─ 03
Bus Table
Opens a menu to define bus table settings for the decoded frames of the acquisition.
See
Chapter 12.1.3, "Bus Table: Decode Results", on page 167.
Label
Opens a menu to define a label for the selected bus.
See
Chapter 12.1.4, "Bus Labels", on page 168.
12.1.2 Display Settings
Access: PROTOCOL > "Display Setup"
Display
Selects the decoding format of the data: binary, hexadecimal, decimal, octal or ASCII.
The setting applies to the data in the combs of the decoded bus line, but not to the bus
table.
Remote command:
BUS<b>:FORMat on page 371
Bits
Enables the display of the individual bit lines above the decoded bus line.
Remote command:
BUS<b>:DSIGnals on page 372
12.1.3 Bus Table: Decode Results
The bus table shows the detailed decoded data for each frame of the acquisition. At
running acquisition, the table results are updated continuously. In stop mode, you can
access the individual frames and analyze them.
To open the bus table
1. In the "Bus" menu, select "Bus Table".
2. Select "Bus Table".
The menu entry gets highlighted, and the bus table is shown below the diagram.
To navigate in the bus table
1. To adjust the table size, drag up or down one of the arrow buttons on the left or
right.
Basics of Protocol Analysis
Loading ...
Loading ...
Loading ...