Loading ...
Loading ...
Loading ...
86
Parameter
Description
Channel
In the Channel list, select the channel that you want to connect
the PTZ camera to.
PTZ Type
Local: Connect through RS485 port or coaxial cable.
Remote: Connect through network by adding IP address of PTZ camera to the
DVR.
Control Mode
In the Control Mode list, select Serial or . For series product,
please select . The control signal is sent to the PTZ through the
coaxial cable. For the serial mode, the control signal is sent to the
PTZ through the RS485 port.
Protocol
In the Protocol list, select the protocol for the PTZ camera, for
example, select 3.0.
Address
In the Address box, enter the address for PTZ camera. The default is 1.
Note: The entered address must be the same as the address configured on the PTZ
camera. If not configured properly, the PTZ camera will not function in the DVR.
Baud Rate
In the Baud rate list, select the baud rate for the PTZ camera. The
default is 9600.
Data Bits
The default is 8.
Stop Bits
The default is 1.
Parity
The default is NONE.
When you have finished setting up your PTZ settings, click on the Apply button to apply the settings to
your DVR. If you would like to revert the settings back to default, click on Default. To apply these settings
to other channels on your DVR, click on the Copy button and select the channels that you wish to apply
the settings to, click OK when you have finished. To exit this screen, press the Back button.
6.1.4.1. PTZ Control Panel
The PTZ control panel is set to perform operations such as directing the camera, adjusting the zoom,
focus, iris, and quick positioning settings.
Note: The PTZ control bar can direct the camera in eight different directions. You can also view the PTZ
control panel by right-clicking on the live view screen.
For more information about the settings listed in the PTZ control bar, refer to the table provided below.
Loading ...
Loading ...
Loading ...