Loading ...
Loading ...
Loading ...
Configuring Routing
190
Insight Managed 28-Port and 52-Port Gigabit Ethernet Smart Cloud Switches
14. In the Adv NS Interval field, specify the retransmission time of router advertisements that
are sent from the interface.
A value of 0 means the interval is not specified. The range of the neighbor solicit interval
is 1000 to 4294967295. The default is 0.
15. In the Adv Reachable Interval field, specify the router advertisement time.
This is the time allocated to consider the neighbors reachable after ND confirmation. The
range of reachable time is 0 to 3600000. The default is 0.
16. Use the Adv Interval field to specify the maximum time allowed between sending router
advertisements from the interface.
The range of the maximum advertisement interval is 4 to 1800. The default value is 600.
17. From the Adv Managed Config Flag menu, specify the setting for the router advertisement
managed address configuration flag.
When the selection is Enable, end nodes use DHCPv6. When the selection is Disable,
end nodes autoconfigure addresses. The default value is Disable.
18. From the Adv Other Config Flag menu, select to enable or disable the router
advertisement other stateful configuration flag.
The default value is Disable.
19. From the Router Preference menu, specify the router preference advertisement on an
interface.
The default value is Medium.
20. From the Adv Suppress Flag menu, select to enable or disable the router advertisement
suppression on an interface.
The default value is Disable.
21. From the Destination Unreachables menu, select to enable or disable the mode for
sending ICMPv6 destination unreachable messages on this interface.
If this mode is disabled, the interface does not send ICMPv6 destination unreachable
messages. The default value is Enable.
22. Click the Apply button.
Your settings are saved.
The following table describes the nonconfigurable information displayed on the page.
Table 52. IPv6 VLAN Configuration information
Field Description
Routing Mode Displays the routing mode of an interface. The default is Disable.
Operational Mode Specifies the operational state of an interface. The default value is
Disable.
Link State Indicates whether the link is up or down.
Loading ...
Loading ...
Loading ...