Loading ...
Loading ...
Loading ...
[Note:]
・[MULTI_PTZ] When UPnP is set to ON and access via the Internet is set to
[Multi-directional + PTZ] by [Live view], only the image of the accessed camera is
displayed.
[Note:]
・Automatic port forwarding may change the port number. If this is changed, the
port number of the camera registered on the PC or recorder must be changed.
・The UPnP feature can be used to connect a camera to an IPv4 network. IPv6 is
not supported.
・To verify that auto-port forwarding has been configured correctly, click on the
[Status] tab on the Maintenance page and make sure that the [UPnP] status is
[On].
→4.12.3 [Status] for checking the status
If [On] is not displayed, please read [Cannot access cameras from internet] in
"Trouble!?"
→5.2 Trouble!?
・If the live screen or configuration screen is not displayed correctly, such as when
replacing the routers to be used, set [UPnP(Auto port forwarding)] to [Off] once
and then set it to [On] again.
4.10.2.4 Set UPnP
This machine supports UPnP (Universal Plug and Play). The UPnP function enables you to set the
following settings automatically.
-configure the port forwarding function for routers. However, a UPnP-enabled router is required.
This setting is useful for accessing the camera from the Internet or from a mobile or tablet
terminal.
-Create a shortcut to the camera in the [Network] folder of the PC and update the shortcut
automatically even if the camera has changed IP addresses.
[Auto port forwarding]
Configure on/off whether to use the router's port forwarding function.
To use the Automatic Port Forwarding feature, the router you use must be UPnP-enabled and
UPnP enabled.
[Camera short cut]
Use the [On] and [Off] buttons to specify whether to make shortcuts to the cameras in the
[Network] folder of your computer.
4 Advanced settings
4.10 Networking configuration [Network]
327
Loading ...
Loading ...
Loading ...