Loading ...
Loading ...
Loading ...
[Important]
・If you need to set the time more accurately in system operation, use the NTP
server.
[Important]
・To obtain [NTP server address] from a DHCP server, you must set [Network
Settings] to DHCP, AutoIP, or Omakase on the [Network] tab of the network
page.
→4.10.1 Networking [Network]
Normally, select [Passive]. If you cannot connect with [Passive], switch to [Active].
[Passive]:Sets FTP communication mode to passive mode.
[Active]:Set FTP communication mode to active mode.
4.10.2.3 Set up an NTP server
This section configures the NTP server, including the address and port number of the NTP server.
[Time adjustment]
Select the time adjustment method from the following. The time adjusted in the selected manner is
used as the standard time of the machine.
[Manual]:The time set in the [Basic] tab on the base page is used as the standard time of the
computer.
[Synchronize to NTP Server]:The time automatically adjusted in synchronization with the NTP
server is used as the standard time of the machine.
[NTP server address setting]
If you selected [Synchronization with NTP server] in [Time adjustment], select how to get the
NTP server address.
[Auto]:Get the NTP server address from the DHCP server.
[Manual]:Enter the NTP server address into the [NTP server address] to configure the NTP
server address.
[NTP server address]
If you selected [Manual] in [NTP server address setting], enter the IP address or hostname of the
NTP server.
Number of characters that can be entered:1 to 128 characters
Input Characters:One-byte alphanumeric and one-byte symbols : . _ -
4 Advanced settings
4.10 Networking configuration [Network]
325
Loading ...
Loading ...
Loading ...