Loading ...
Loading ...
Loading ...
[Note:]
・Automatic tracking is not available in the following cases.
-When [Image capture mode] is [16:9 (60 fps mode)], [16:9 (50 fps mode)], [4:3
(15 fps mode)], [4:3 (12.5 fps mode)]
-When the [Light control mode] [Maximum shutter] of [Image adjust] is set to the
following
Maximum 2/30s/Maximum 4/30s/Maximum 6/30s/Maximum 10/30s/Maximum
16/30s
・If the automatic tracking function is used for a long time, the drive parts may be
consumed and the replacement cycle of consumables may be faster. For
consumables, refer to the Web Guide.
→4.8.1 [Alarm] to set alarm operation
② Set the [Alarm] [Command alarm] to [On] and press [Set].
③ Set the [Camera action on alarm] [Command alarm] to [Preset per sender] and press
[Preset per sender].
④ On the Preset by Source window, check Auto Tracking of [Source Address 1] (any Source
Address may be selected), enter the Source Address 192.168.0.11 (Camera 1), select the
preset position to move when receiving the command set in step 2, click [Set], and close
the pages.
→4.8.4.1 Set the preset position by source (screen for setting preset position by source)
⑤ Press [Set].
5 By starting the automatic tracking operation of camera 1, the automatic tracking linkage
function can be used.
4.7.4 Set Auto Track Alarm (Auto Track Alarm screen)
Click on the [Auto track alarm setting] tab of the PTZ page. Here, you can set the automatic
tracking alarm.
The auto tracking function automatically tracks and shoots the subject when movement is
detected in the pre-set alarm area.
4 Advanced settings
4.7 Set PTZ
252
Loading ...
Loading ...
Loading ...