FLUKE 9935-S LogWare II Software

User Manual for the Fluke 9935-S LogWare II Software - Page 93

For 9935-S.

PDF File Manual, 275 pages, Read Online | Download pdf file

9935-S photo
Loading ...
Loading ...
Loading ...
clicked, this dialog remains open. If the OK button is clicked, this dialog closes
after writing the settings.
LogWare has a feature that causes all of the channel settings to be read back in
from the thermometer readout after the Apply button is clicked and the new set
-
tings have been written to the thermometer readout. This feature can be useful
to verify that the desired settings were properly applied to the thermometer
readout. To enable or disable this feature, see Section 5.6.4, Options.
To close this dialog without writing the channel settings to the thermometer
readout, click the Cancel button.
Click the Help button to open the appropriate help topic for this dialog.
4.4.1.6.1 Probe tab
Select the Probe tab to view and/or modify probe settings.
Enter the serial number of the probe attached to this channel in the probe serial
number box. The serial number can be any combination of numbers and/or let
-
ters up to 8 characters in length. The underscore “_“ character can also be used
in serial numbers.Select the date this probe was last calibrated using the
drop-down calendar or by entering the date. This date should be located on the
Report of Calibration for the probe.
Select the appropriate probe type for this probe using the Probe Type
drop-down list. Currently, the only choice is TC.
User’s Guide
82
Figure 53 1523/1524 Thermocouple Channel Settings – Probe tab
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...