Loading ...
Loading ...
Loading ...
only be loaded if the Show Log Session Settings dialog on start-up and Load
default configuration file automatically options are both checked. Use the “…”
(Browse) button to locate the configuration file to be used as the default config
-
uration file.
The Show Log Session Settings dialog after closing log session option deter
-
mines whether the Log Session Settings dialog is displayed after the real-time
log session window is closed. All real-time log session settings are still active
in LogWare after a log session is closed. To access the Log Session Settings di
-
alog, select the Setup option in the Datalog menu. If this option is not checked,
this dialog is not displayed when the log session window is closed.
The Prompt to synchronize real-time log session option determines whether or
not a prompt is displayed when the real-time log session is initialized and ready
to start acquiring data. This prompt can be used to facilitate synchronizing
LogWare with another process or application. If this option is not checked,
LogWare begins acquiring data immediately after initialization of the session is
complete.
Note: When using the delayed start feature of LogWare to start a log ses-
sion unattended, make sure this setting is not checked! Otherwise, the log
session may not start as expected!
The Wait until new measurement is ready (when applicable) option determines
whether LogWare should always wait until the thermometer readout indicates a
new measurement is ready on the current channel before querying the measure-
ment during a real-time log session. If this option is not checked, LogWare al-
ways queries the last measurement taken on the current channel.
Not all thermometers supported by LogWare support waiting until a new mea-
surement is ready. For these thermometer readouts, LogWare always queries the
last measurement taken on the current channel.
Note: This option is protected by the administrator passcode. To change
this setting, the correct administrator passcode must be entered. For more
information, see Section 5.6.4.4, Admin. Passcode Tab.
The Always prompt to select printer before printing option determines whether
the Print Setup dialog is displayed when printing. The Print Setup dialog allows
the printer to be selected as well as the paper size, source and orientation set
-
tings (as supported by the selected printer driver). If this option is not checked,
LogWare always prints to the default printer using that printer’s default settings.
The Always print statistics with readings option determines whether LogWa re
appends statistical data to the end of the readings when printing an output file.
If this option is checked, the statistical data is printed.
195
5 Menus
Tools menu
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...