Loading ...
Loading ...
Loading ...
The Low alarm tab and High alarm tab indicate the current low alarm and high
alarm settings for the selected channel respectively.
To enable an alarm for the selected channel, check the Enable alarm check box
on the appropriate tab. If this check box is unchecked, all other settings on the
tab are disabled.
Enter the value to be used for this alarm in the Value box. The low alarm will
be tripped if the reading on the selected channel meets or drops below the value
on the Low alarm tab. The high alarm will be tripped if the reading on the se
-
lected channel meets or exceeds the value on the High alarm tab.
Select the event that should occur when each alarm is tripped. The choices are:
•
No event
•
System beep
•
Display message
•
Play .WAV file indicated below
• Launch .EXE file indicated below
If either the Play .WAV file indicated below or Launch .EXE file indicated be-
low option is selected, the Path and filename box and Browse button are en-
abled and the appropriate file must be entered or selected. Use the Browse
button to browse for the file. The Test button is enabled once a file has been en-
tered. Select the Test button to make sure the selected file can be played or
launched.
Note: The file entered in the Path and filename box MUST exist! When the
OK button is clicked, a search is performed to locate the file. If the file is
not found, a warning message is displayed. If the selected file resides on a
network resource, the resource must be available and properly connected
when the alarm event occurs!
LogWare ships with a few sample .WAV files that can be used. These files are
located in the \Config folder.
The Launch .EXE file indicated below option can be used to launch any appli
-
cation such as pager software which could be configured to dial a phone num
-
ber automatically and transmit a fixed message to a pager indicating that an
alarm has tripped.
User’s Guide
28
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...