Loading ...
Loading ...
Loading ...
4.4.4.2 Sampling tab
Select the Sampling tab to view and/or modify sampling settings.
Select the units using the Units drop-down list. Readings can be displayed in
either °C, °F, K, Ohms, Ratio or W.
Note: This setting may override the selected conversion type for each
channel. Please refer to the thermometer readout’s User’s Guide for more
information on setting the system units.
Select the sample action from the Sample action drop-down list. The sample
action can be set to one of the following options:
•
Run
•
Stop
•
Sample n
If the sample action is set to Run or Stop, the Sample n setting is not applicable
and is disabled. If the filter type is set to Sample n,theSamplen setting is
enabled.
If the sample action is set to Sample n, enter the number of samples in the Sam
-
ple n box. The Sample n setting can be set to any value between 1 and 32,000.
The Sample timing controls allow the thermometer readout’s sample timing set
-
tings to be viewed and/or modified. The sample timing settings include the
Sample interval, Integration time and Conversion time.
Enter the sample interval value in the Sample interval box provided or use the
up/down buttons. The sample interval can be set to any value between 2 and
99,999 seconds.
User’s Guide
140
Figure 114 1575A Super-Thermometer Settings -
Sampling tab
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...