Loading ...
Loading ...
Loading ...
•
Polynomial
•
Ohms
Refer to the Report of Calibration for the selected probe for information on the
conversion type that the probe was calibrated for.
If the selected conversion type requires coefficients or other settings, the Con
-
version Settings button is enabled. Click the Conversion Settings button to dis
-
play the dialog for the selected conversion type. Otherwise, the Conversion
Settings button is disabled.
Note: The conversion settings are not written to the thermometer readout
until the Apply or OK button is clicked on this dialog!
4.4.6.7 1594A/1595A Hart Super-Thermometer Channel Settings dialog
The 1594A/1595A Hart Super-Thermometer channel settings dialog displays
information pertaining to the current channel selection.
After modifying any of the settings on this dialog, click the Apply or OK but
-
ton to write the new settings to the thermometer readout. If the Apply button is
clicked, this dialog remains open. If the OK button is clicked, this dialog closes
after writing the settings.
To close this dialog without writing the channel settings to the thermometer
readout, click the Cancel button.
Click the Help button to open the appropriate help topic for this dialog.
Use the Reference drop-down list to select the reference resistor for the se
-
lected channel. Possible internal reference resistor values are 1 ohm, 10 ohm,
User’s Guide
168
Figure 135 1594A/1595A Hart Super-Thermometer Channel settings
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...