Loading ...
Loading ...
Loading ...
played. The other controls on this tab are disabled. To edit the calibration pa
-
rameters, click the Edit button and enter the current passcode for the
thermometer readout. If the correct passcode is entered, the calibration parame
-
ter controls are enabled and the values may be changed. The controls remain
enabled until this dialog is closed or until the current changes are applied by
clicking the Apply button.
Caution: Do not change these values unless this module has been
recalibrated or unless these values do not match the values located on the
latest Report of Calibration for this module! Changing these values voids
the current calibration!
Select the date this module was last calibrated using the drop-down calendar or
by entering the date. This date should be located on the Report of Calibration
for this module.
Enter the values for the calibration constants in the boxes provided. The cali
-
bration constants required by the 2562 module are: 0 ADJ, 100 ADJ and 400
ADJ. The values of these constants should be located on the Report of Calibra-
tion for this module.
4.4.3.8 2563 STHR Module Settings dialog
The 2563 Module Settings dialog displays information about the 2563 module
including model number, serial number, identification information and the
number of channels on this module. It also allows many module specific set-
tings to be viewed and/or modified.
111
4 Tools
Thermometer settings dialogs
Figure 84 2563 STHR Module Settings dialog
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...