Loading ...
Loading ...
Loading ...
If any of the settings on the 1594A/1595A Hart Super-Thermometer Settings
dialog are passcode protected, a message appears at the bottom of the appropri
-
ate tab and the Edit button is displayed. The controls for the passcode protected
settings are disabled. To edit the protected settings, click the Edit button and
enter the current passcode for the thermometer readout. If the correct passcode
is entered, the controls are enabled and the values may be changed.
After modifying any of the settings on this dialog, click the Apply or OK but
-
ton to write the new settings to the thermometer readout. If the Apply buttons
clicked, this dialog remains open. If the OK button is clicked, this dialog closes
after writing the settings.
LogWare has a feature that causes all of the thermometer readout settings to be
read back in from the thermometer readout after the Apply button is clicked
and the new settings have been written to the thermometer readout. This feature
can be useful to verify that the desired settings were properly applied to the
thermometer readout. To enable or disable this feature, see Section 5.6.4,
Options.
To close this dialog without writing the settings to the thermometer readout,
click the Cancel button.
Click the Help button to open the appropriate help topic for this dialog.
4.4.6.1 Filtering tab
Select the Filtering tab to view and/or modify the filter settings.
161
4 Tools
Thermometer settings dialogs
Figure 129 1594A/1595A Hart Super-Thermometer Filtering tab
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...