Loading ...
Loading ...
Loading ...
4.4.1.5 1523/1524 PRT/thermistor channel settings dialog
The 1523/1524 PRT/Thermistor Channel Settings dialog displays information
about the selected channel.
Some or all of the settings on this dialog may be passcode protected. If so, a
message appears at the bottom of the Probe tab and the Edit button is dis
-
played. The protected controls are disabled. To edit the protected settings, click
the Edit button and enter the current passcode for the thermometer readout. If
the correct passcode is entered, the protected controls are enabled and the val
-
ues may be changed. The controls remain enabled until this dialog is closed or
until the current changes are applied by clicking the Apply button.
After modifying any of the settings on this dialog, click the Apply or OK but
-
ton to write the new settings to the thermometer readout. If the Apply button is
clicked, this dialog remains open. If the OK button is clicked, this dialog closes
after writing the settings.
LogWare has a feature that causes all of the channel settings to be read back in
from the thermometer readout after the Apply button is clicked and the new set
-
tings have been written to the thermometer readout. This feature can be useful
to verify that the desired settings were properly applied to the thermometer
readout. To enable or disable this feature, see Section 5.6.4, Options.
To close this dialog without writing the channel settings to the thermometer
readout, click the Cancel button.
User’s Guide
78
Figure 49 1523/1524 PRT/Thermistor Channel Settings dialog
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...