Loading ...
Loading ...
Loading ...
LogWare has a feature that causes all of the channel settings to be read back in
from the thermometer readout after the Apply button is clicked and the new set
-
tings have been written to the thermometer readout. This feature can be useful
to verify that the desired settings were properly applied to the thermometer
readout. To enable or disable this feature, see Section 5.6.4, Options.
To close this dialog without writing the channel settings to the thermometer
readout, click the Cancel button.
Click the Help button to open the appropriate help topic for this dialog.
4.4.4.6.1 Probe tab
Select the Probe tab to view and/or modify probe settings.
Enter the serial number of the selected probe in the Probe serial number box.
The serial number can be any combination of numbers and/or letters up to 8
characters in length. The dash “-“ character can also be used in serial numbers.
Select the reference resistor for the selected probe using the Reference
drop-down list. The choices for the reference resistor are:
•
External resistor
•
1 Ohm
•
10 Ohm
•
100 Ohm
•
10K Ohm
Note: The External resistor option is not available for Input 2 because the
external reference resistor must be connected to Input 2!
147
4 Tools
Thermometer settings dialogs
Figure 119 1575A Super-Thermometer/2575
Mighty Mux Channel Settings - Probe tab
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...