Loading ...
Loading ...
Loading ...
the list may be limited depending on the thermocouple types supported by the
thermometer readout being used.
The Temperature and Offset boxes provide a method to use an offset table with
this thermocouple type. Up to three Temperature/Offset pairs can be entered. If
no offset table is to be used, make sure the values in the Offset boxes are all set
to 0.0.
Note: If any one of the temperature values is set to 0°C, that point is ig
-
nored because the voltage on a thermocouple at 0°C is always assumed to
be 0mV.
If the selected thermocouple type is type S or type R, the DC1 and DC2 boxes
are displayed. The DC1 and DC2 values are delta (Δ) values for the standard
C1 and C2 polynomial coefficients. Enter the values for DC1 and DC2. These
values should be located on the Report of Calibration.
Select the Open button to display the Windows® Open dialog to open a previ
-
ously saved configuration file which contains Thermocouple Type coefficients.
Select the Save As button to display the Windows® Save As dialog to save the
current Thermocouple Type coefficients to a configuration file.
Click the OK button to accept the current coefficients and close this dialog.
Click the Cancel button to discard any changes you have made and close this
dialog.
Click the Help button to display the appropriate help topic for this dialog.
253
9 Conversion settings dialogs
Thermocouple Type Settings dialog
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...