Loading ...
Loading ...
Loading ...
abled. To edit the protected settings, click the Edit button and enter the currentabled. To edit the protected settings, click the Edit button and enter the current
passcode for the thermometer readout. If the correct passcode is entered, the
controls are enabled and the values may be changed. The controls remain en
-
abled until this dialog is closed or until the current changes are applied by
clicking the Apply button.
After modifying any of the settings on this dialog, click the Apply or OK but
-
ton to write the new settings to the thermometer readout. If the Apply button is
clicked, this dialog remains open. If the OK button is clicked, this dialog closes
after writing the settings.
LogWare has a feature that causes all of the thermometer readout settings to be
read back in from the thermometer readout after the Apply button is clicked
and the new settings have been written to the thermometer readout. This feature
can be useful to verify that the desired settings were properly applied to the
thermometer readout. To enable or disable this feature, see Section 5.6.4,
Options.
To close this dialog without writing the settings to the thermometer readout,
click the Cancel button.
Click the Help button to open the appropriate help topic for this dialog.
4.4.1.1 Sampling tab
Select the Sampling tab to view and/or modify sampling settings.
Select the units to use when displaying readings in temperature using the Units
drop-down list. Temperature readings can be displayed in either °C or °F. This
setting applies to all channels that are configured to display readings in
temperature.
User’s Guide
74
Figure 45 1523/1524 Settings – Sampling tab
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...