Loading ...
Loading ...
Loading ...
[Important]
・To enter a hostname for [NTP server address], you must configure the DNS on
the [Network] tab of the network page.
→4.10.1 Networking [Network]
[Note:]
・[MULTI] The port numbers 32768 to 49151 cannot be set.
[Note:]
・When the NTP test is successful, the [The NTP time correction completed
successfully.] is displayed.
・If the NTP test fails, the [The NTP time correction failed.] is displayed.
・If [Time adjustment] is set to [Manual], the [Execute] buttons for NTP tests will
be grayed out.
・If [Time adjustment] is set to [Synchronization with NTP server] and the NTP
server address is not set, the [Execute] buttons for the NTP tests are grayed out.
[NTP port]
Enter the port number of the NTP server.
Configurable port number:1～65535
The following port numbers cannot be set because they are used by this computer.
20、 21、 22、 23、 25、 42、 53、 67、 68、 69、 80 110、 123、 161、 162、 443、 554、 995、
1883、 8883、 10669、 10670、 59000～61000
[Time adjustment interval]
Select the interval (in 1-24 hour increments) at which the time is to be acquired from the NTP
server.
[NTP test]
Select [Synchronization with NTP server] for [Time adjustment], set up the NTP server, and then
press [Execute]. You can communicate with the NTP server, perform time synchronization, and
check the NTP operation.
4 Advanced settings
4.10 Networking configuration [Network]
326
Loading ...
Loading ...
Loading ...