Loading ...
Loading ...
Loading ...
[Note:]
・Automatic port forwarding may change the port number. If this is changed, the
port number of the camera registered on the PC or recorder must be changed.
・The UPnP feature can be used to connect a camera to an IPv4 network. IPv6 is
not supported.
・To verify that auto-port forwarding has been configured correctly, click on the
[Status] tab on the Maintenance page and make sure that the [UPnP] status is
[On].
→4.12.3 [Status] for checking the status
If [On] is not displayed, please read [Cannot access cameras from internet] in
"Trouble!?"
→5.2 Trouble!?
・If you change the [UPnP(Auto port forwarding)] settings, the [UPnP] on the
[Advanced] tabs of the network pages will also change.
・If the live screen or configuration screen is not displayed correctly, such as when
replacing the routers to be used, set [UPnP(Auto port forwarding)] to [Off] once
and then set it to [On] again.
Confirms made selections.
4.4.2 [Internet] to set up an Internet-based disclosure system
Click the [Internet] tab for easy setting. Refer to the table below for how to display and operate
the setting menu.
→4.2.1 How to display
→4.2.2 How to operate
This is to configure the UPnP (Automatic Port Forwarding), DDNS, and Internet Recommendation
settings that are required to publish the camera on the Internet.
[UPnP(Auto port forwarding)]
You can configure [On]/[Off] to use the router's port forwarding capability.
To use the Automatic Port Forwarding feature, the router you use must be UPnP-enabled and
UPnP enabled.
[Area]
Select the region where the camera is installed.
[Global]/[Japan]
4 Advanced settings
4.4 [Easy Setup] to use easy setting
117
Loading ...
Loading ...
Loading ...