Loading ...
Loading ...
Loading ...
[Note:]
・If [Recording format] is streamed, [FTP/SFTP periodic image transmission error]
cannot be set.
・To generate an alarm, use the [Alarm] tabs to set the alarm.
・If [Recording format] is [JPEG], [Schedule] cannot be set.
・When connected to our network disk recorder, [Save trigger] may be grayed out
by [Network failure]. To change the [Save trigger] setting after you disconnect
the recorder, set [SD memory card] to [Not use] and then set [Use] again.
・If [GOP control] is set to Advanced (Fixed GOP 60s + 1s keyframe), alarm
recording cannot be set.
・Images are not recorded when sound detection alarm is generated.
JPEG manual storage recording
This setting is available only when [Recording format] is set to [JPEG(1)] or [JPEG(2)] and [Save
trigger] is set to [Manual].
[File name]
Enter the file name for saving images to the SD Memory Card. The following file names are
actually saved.
File name:File name entered + Date and time (year, month, day, minute, second) + Sequence
number
Number of characters that can be entered:1 to 8 characters
Characters that cannot be entered:Double-byte and single-byte symbols " & * / : ; < > ? ￥ ¦
[Image saving interval]
If [Save trigger] is set to [Manual], select the interval to save images to the SD Memory Card from
the following.
When [Image capture mode] is set to 30 fps/15 fps: 0.1 fps/0.2 fps/0.33 fps/0.5 fps/1 fps
When [Image capture mode] is set to 25 fps/12.5 fps: 0.08 fps/0.17 fps/0.28 fps/0.42 fps/1 fps
JPEG recording (when alarm occurs)
4 Advanced settings
4.5 [Basic] for basic setup of the machine
157
Loading ...
Loading ...
Loading ...