Loading ...
Loading ...
Loading ...
*3: 1st trip DTC No. is the same as DTC No.
*4: SRT code will not be set if the self-diag result is NG.
HOW TO ERASE EMISSION-RELATED DIAGNOSTIC INFORMATION
NGEC0031S06
How to Erase DTC (With CONSULT-II)
NGEC0031S0601
1. If the ignition switch stays ON after repair work, be sure to turn ignition switch OFF once. Wait at least 5
seconds and then turn it ON (engine stopped) again.
2. Turn CONSULT-II “ON” and touch “ENGINE”.
3. Touch “SELF-DIAG RESULTS”.
4. Touch “ERASE”. (The DTC in the ECM will be erased.)
SEF823YD
The emission-related diagnostic information can be erased by selecting “ERASE” in the “SELF-DIAG
RESULTS” mode with CONSULT-II.
How to Erase DTC (With GST)
NGEC0031S0602
1. If the ignition switch stays ON after repair work, be sure to turn ignition switch OFF once. Wait at least 5
seconds and then turn it ON (engine stopped) again.
2. Select Mode 4 with GST (Generic Scan Tool).
The emission-related diagnostic information in the ECM can be erased by selecting Mode 4 with GST (Generic
Scan Tool).
NOTE:
쐌 If the battery is disconnected, the emission-related diagnostic information will be lost after approx.
24 hours.
쐌 The following data are cleared when the ECM memory is erased.
1) Diagnostic trouble codes
2) 1st trip diagnostic trouble codes
ON BOARD DIAGNOSTIC SYSTEM DESCRIPTION
KA24DE
Emission-related Diagnostic Information (Cont’d)
EC-79
FE
CL
MT
AT
TF
PD
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
GI
MA
EM
LC
Loading ...
Loading ...
Loading ...