User Manual - Page 340

For 2001 XTERRA.

Loading ...
Loading ...
Loading ...
SEF930VA
SEF718Z
SEF719Z
SEF720Z
SEF384X
DTC Confirmation Procedure
NGEC0236
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
If DTC Confirmation Procedure has been previously conducted,
always turn ignition switch OFF and wait at least 5 seconds before
conducting the next test.
TESTING CONDITION:
Always perform at a temperature above 5°C (41°F).
Before performing the following procedure, confirm that
battery voltage is more than 11V at idle.
With CONSULT-II
1) Install vacuum gauge between EGRC-BPT valve and EGR
valve as shown in the illustration.
2) Start engine and warm it up to normal operating temperature.
3) Stop engine and wait at least 5 seconds.
4) Turn ignition switch ON and select EGRC-BPT/V P0402 of
EGR SYSTEM in DTC WORK SUPPORT mode with CON-
SULT-II.
5) Start engine and let it idle.
6) Touch START.
7) Check the output voltage of THRTL POS SEN (at closed
throttle position) and note it.
8) When the following conditions are met, TESTING will be dis-
played on the CONSULT-II screen and the bar chart may
increase. Maintain the conditions many times until COM-
PLETED appears.
Selector lever Suitable position
ENG SPEED 1,400 - 2.000 rpm
Vehicle speed 30 - 100 km/h (19 - 62 MPH)
B/FUEL SCHDL 5 - 7.5 msec
THRTL POS SEN (X-(X+0.88) V
X = Voltage value measured at step 7
NOTE:
The bar chart on CONSULT-II screen indicates the status
of this test. However, the test may be finished before the
bar chart becomes full scale.
If the bar chart indication does not continue to progress,
completely release accelerator pedal once and try to meet
the conditions again.
If TESTING does not appear on CONSULT-II screen, retry
from step 2.
9) If CONSULT-II instructs to carry out Overall Function Check,
go to next step. If NG is displayed, refer to Diagnostic
Procedure, EC-342.
10) Open engine hood.
11) Raise engine speed to 2,400 to 3,200 rpm under no-load and
hold it. Then touch NEXT on CONSULT-II screen.
DTC P0402 EGRC-BPT VALVE FUNCTION
KA24DE
On Board Diagnosis Logic (Contd)
EC-340
Loading ...
Loading ...
Loading ...