Loading ...
Loading ...
Loading ...
6 CHECK FOR EVAP LEAK
With CONSULT-II
1. Turn ignition switch “ON”.
2. Select “EVAP SYSTEM CLOSE” of “WORK SUPPORT” mode with CONSULT-II.
3. Touch “START” and apply pressure into the EVAP line until the pressure indicator reaches the middle of the bar graph.
NOTE:
쐌 Never use compressed air or a high pressure pump.
쐌 Do not exceed 4.12 kPa (0.042 kg/cm
2
, 0.6 psi) of pressure in the system.
PEF917U
4. Using EVAP leak detector, locate the EVAP leak. For the leak detector, refer to the instruction manual for more details.
Refer to “EVAPORATIVE EMISSION LINE DRAWING”, EC-37.
SEF200U
OK or NG
OK 䊳 GO TO 8.
NG 䊳 Repair or replace.
DTC P1441 EVAP CONTROL SYSTEM (VERY SMALL LEAK)
KA24DE
Diagnostic Procedure (Cont’d)
EC-482
Loading ...
Loading ...
Loading ...