Loading ...
Loading ...
Loading ...
Diagnostic Procedure
NGEC0900
FOR M/T MODELS
NGEC0900S01
1 CHECK PNP SWITCH GROUND CIRCUIT FOR OPEN AND SHORT
1. Turn ignition switch OFF.
2. Disconnect park/neutral position (PNP) switch harness connector.
AEC877A
3. Check harness continuity between PNP switch terminal 2 and engine ground. Refer to Wiring Diagram.
Continuity should exist.
4. Also check harness for short to power.
OK or NG
OK 䊳 GO TO 3.
NG 䊳 GO TO 2.
2 DETECT MALFUNCTIONING PART
Check the following.
쐌 Harness connectors F201, F43
쐌 Harness for open between park/neutral position (PNP) switch and engine ground
䊳 Repair open circuit or short to power in harness or connectors.
3 CHECK PNP SWITCH INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT
1. Disconnect ECM harness connector.
2. Check harness continuity between ECM terminal 22 and PNP switch terminal 1. Refer to Wiring Diagram.
Continuity should exist.
3. Also check harness for short to ground and short to power.
OK or NG
OK 䊳 GO TO 5.
NG 䊳 GO TO 4.
4 DETECT MALFUNCTIONING PART
Check the following.
쐌 Harness connectors F43, F201
쐌 Harness for open or short between ECM and park/neutral position (PNP) switch
䊳 Repair open circuit or short to ground or short to power in harness or connectors.
5 CHECK PARK/NEUTRAL POSITION (PNP) SWITCH
Refer to “Position Switch Check”, “ON-VEHICLE SERVICE”, MT-8.
OK or NG
OK 䊳 GO TO 6.
NG 䊳 Replace park/neutral position (PNP) switch.
DTC P1706 PARK/NEUTRAL POSITION (PNP) SWITCH
VG33E
Diagnostic Procedure
EC-1157
GI
MA
EM
LC
FE
CL
MT
AT
TF
PD
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
Loading ...
Loading ...
Loading ...