Loading ...
Loading ...
Loading ...
SEF212Y
DTC Confirmation Procedure
=NGEC0428
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
If “DTC Confirmation Procedure” has been previously conducted,
always turn ignition switch “OFF” and wait at least 5 seconds
before conducting the next test.
With CONSULT-II
1) Turn ignition switch ON.
SEF213Y
2) Select “P/N POSI SW” in “DATA MONITOR” mode with CON-
SULT-II. Then check the “P/N POSI SW” signal under the fol-
lowing conditions.
Position (Selector lever) Known good signal
“N” ON
Except the above position OFF
If NG, go to “Diagnostic Procedure”, EC-552.
If OK, go to following step.
3) Select “DATA MONITOR” mode with CONSULT-II.
4) Start engine and warm it up to normal operating temperature.
5) Maintain the following conditions for at least 60 consecutive
seconds.
ENG SPEED 1,400 - 4,000 rpm
COOLAN TEMP/S More than 70°C (158°F)
B/FUEL SCHDL 3.5 - 17 msec
VHCL SPEED SE More than 64 km/h (40 MPH)
Selector lever Suitable position
6) If 1st trip DTC is detected, go to “Diagnostic Procedure”,
EC-552.
DTC P1706 PARK/NEUTRAL POSITION (PNP) SWITCH
KA24DE
DTC Confirmation Procedure
EC-549
FE
CL
MT
AT
TF
PD
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
GI
MA
EM
LC
Loading ...
Loading ...
Loading ...