Loading ...
Loading ...
Loading ...
SEF800Z
Component Description
NGEC1022
The fuel level sensor is mounted in the fuel level sensor unit. The
sensor detects a fuel level in the fuel tank and transmits a signal
to the ECM.
It consists of two parts, one is mechanical float and the other side
is variable resistor. Fuel level sensor output voltage changes
depending on the movement of the fuel mechanical float.
On Board Diagnostic Logic
NGEC1023
ECM receives two signals from the fuel level sensor circuit.
One is fuel level sensor power supply circuit, and the other is fuel
level sensor ground circuit.
This diagnosis indicates the former, to detect open or short circuit
malfunction.
Malfunction is detected when an excessively low or high voltage is
sent from the sensor is sent to ECM.
Possible Cause
NGEC1024
쐌 Fuel level sensor circuit
(The fuel level sensor circuit is open or shorted.)
쐌 Fuel level sensor
DTC Confirmation Procedure
NGEC1025
NOTE:
If “DTC Confirmation Procedure” has been previously conducted,
always turn ignition switch “OFF” and wait at least 10 seconds
before conducting the next test.
TESTING CONDITION:
Before performing the following procedure, confirm that bat-
tery voltage is more than 11V at ignition switch “ON”.
SEF195Y
WITH CONSULT-II
NGEC1025S01
1) Turn ignition switch “ON”.
2) Select “DATA MONITOR” mode with CONSULT-II.
3) Wait at least 5 seconds.
4) If 1st trip DTC is detected, go to “Diagnostic Procedure”,
EC-421.
WITH GST
NGEC1025S02
Follow the procedure “WITH CONSULT-II” above.
DTC P0464 FUEL LEVEL SENSOR CIRCUIT
KA24DE
Component Description
EC-419
FE
CL
MT
AT
TF
PD
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
GI
MA
EM
LC
Loading ...
Loading ...
Loading ...