Loading ...
Loading ...
Loading ...
11 CHECK EVAP CANISTER
Weigh the EVAP canister with EVAP canister vent control valve attached.
The weight should be less than 1.8 kg (4.0 lb).
OK or NG
OK (With CONSULT-II) 䊳 GO TO 13.
OK (Without CONSULT-
II)
䊳 GO TO 14.
NG 䊳 GO TO 12.
12 DETECT MALFUNCTIONING PART
Check the following.
1. Visually check the EVAP canister for damage.
2. Check hose connection between EVAP canister and water separator for clogging and poor connection.
䊳 Repair hose or replace EVAP canister.
13 CHECK EVAP CANISTER PURGE VOLUME CONTROL SOLENOID VALVE
With CONSULT-II
1. Disconnect vacuum hose to EVAP canister purge volume control solenoid valve at EVAP service port.
2. Start engine.
3. Perform “PURG VOL CONT/V” in “ACTIVE TEST” mode.
SEF595Y
4. Touch “Qu” on CONSULT-II screen to increase “PURG VOL CONT/V” opening to 100.0%.
5. Check vacuum hose for vacuum.
Vacuum should exist.
OK or NG
OK 䊳 GO TO 17.
NG 䊳 GO TO 15.
14 CHECK EVAP CANISTER PURGE VOLUME CONTROL SOLENOID VALVE
Without CONSULT-II
1. Start engine and warm it up to normal operating temperature.
2. Stop engine.
3. Disconnect vacuum hose to EVAP canister purge volume control solenoid valve at EVAP service port.
4. Start engine and let it idle for at least 60 seconds.
5. Check vacuum hose for vacuum.
Vacuum should exist.
OK or NG
OK 䊳 GO TO 17.
NG 䊳 GO TO 15.
DTC P0440 EVAP CONTROL SYSTEM (SMALL LEAK)
(NEGATIVE PRESSURE)
KA24DE
Diagnostic Procedure (Cont’d)
EC-362
Loading ...
Loading ...
Loading ...