Loading ...
Loading ...
Loading ...
SEF327R
Component Description
NGEC0144
The heated oxygen sensor 2 (rear), after three way catalyst, moni-
tors the oxygen level in the exhaust gas.
Even if switching characteristics of the heated oxygen sensor 1
(front) are shifted, the air fuel ratio is controlled to stoichiometric,
by the signal from the heated oxygen sensor 2 (rear).
This sensor is made of ceramic zirconia. The zirconia generates
voltage from approximately 1V in richer conditions to 0V in leaner
conditions.
Under normal conditions the heated oxygen sensor 2 (rear) is not
used for engine control operation.
CONSULT-II Reference Value in Data Monitor
Mode
NGEC0145
Specification data are reference values.
MONITOR ITEM CONDITION SPECIFICATION
HO2S2 (B1)
쐌 Engine: After warming up
Revving engine from idle to 3,000
rpm
0 - 0.3V +, Approx. 0.6 - 1.0V
HO2S2 MNTR
(B1)
LEAN +, RICH
ECM Terminals and Reference Value
NGEC0146
Specification data are reference values and are measured between each terminal and ground.
CAUTION:
Do not use ECM ground terminals when measuring input/output voltage. Doing so may result in dam-
age to the ECM’s transistor. Use a ground other than ECM terminals, such as the ground.
TERMI-
NAL
NO.
WIRE
COLOR
ITEM CONDITION DATA (DC Voltage)
56 OR
Heated oxygen sensor 2
(rear)
[Engine is running]
쐌 After warming up to normal operating temperature
and revving engine from idle to 3,000 rpm quickly
0 - Approximately 1.0V
SEF304U
On Board Diagnosis Logic
NGEC0147
The heated oxygen sensor 2 (rear) has a much longer switching
time between rich and lean than the heated oxygen sensor 1
(front). The oxygen storage capacity before the three way catalyst
causes the longer switching time. To judge the malfunctions of rear
heated oxygen sensor, ECM monitors whether the minimum volt-
age of the sensor is sufficiently low during various driving condi-
tions such as fuel-cut.
DTC No. Malfunction is detected when ... Check Items (Possible Cause)
P0137 쐌 The minimum voltage from the sensor does not reach the
specified voltage.
쐌 Harness or connectors
(The sensor circuit is open or shorted.)
쐌 Heated oxygen sensor 2 (rear)
쐌 Fuel pressure
쐌 Injectors
DTC P0137 HEATED OXYGEN SENSOR 2 (REAR)
(MIN. VOLTAGE MONITORING)
KA24DE
Component Description
EC-237
FE
CL
MT
AT
TF
PD
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
GI
MA
EM
LC
Loading ...
Loading ...
Loading ...