Loading ...
Loading ...
Loading ...
17 ADJUSTMENT THROTTLE POSITION SENSOR IDLE POSITION-1
Without CONSULT-II
NOTE:
쐌 Never adjust throttle adjust screw (TAS).
쐌 Do not touch throttle drum when checking “continuity”.
Doing so may cause an incorrect adjustment.
1. Warm engine up to normal operating temperature.
2. Check FI cam. Refer to procedure 5.
3. Stop engine.
4. Loosen throttle position sensor fixing bolts.
5. Disconnect closed throttle position sensor harness connector.
6. Insert 0.1 mm (0.004 in) feeler gauge between the throttle adjust screw and throttle drum as shown in the figure.
AEC871A
7. Open throttle valve then close.
8. Check continuity between closed throttle position switch terminal 5 and 6.
SEF862V
The continuity should not exist while closing the throttle position sensor body.
If it is impossible to adjust closed throttle position switch, replace throttle position sensor.
OK or NG
OK 䊳 GO TO 19.
NG 䊳 GO TO 18.
TROUBLE DIAGNOSIS — BASIC INSPECTION
KA24DE
Basic Inspection (Cont’d)
EC-115
FE
CL
MT
AT
TF
PD
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
GI
MA
EM
LC
Loading ...
Loading ...
Loading ...