Loading ...
Loading ...
Loading ...
25 REINSTALLATION
Without CONSULT-II
1. Reconnect throttle position sensor harness connector and closed throttle position switch harness connector.
2. Start engine and rev it (2,000 to 3,000 rpm) two or three times under no-load and then run engine at idle speed.
䊳 GO TO 26.
26 CHECK TARGET IDLE SPEED
Without CONSULT-II
1. Start engine and warm it up to normal operating temperature.
2. Check idle speed.
750±50 rpm (in “P” or “N” position)
OK or NG
OK 䊳 GO TO 27.
NG 䊳 1. Adjust idle speed. Refer to “Idle Speed/Ignition Timing/Idle Mixture Ratio Adjustment”,
EC-641.
2. GO TO 27.
27 ERASE UNNECESSARY DTC
After this inspection, unnecessary DTC No. might be displayed.
Erase the stored memory in ECM and TCM (Transmission control module).
Refer to “HOW TO ERASE EMISSION-RELATED DIAGNOSTIC INFORMATION”, EC-666 and “HOW TO ERASE DTC”,
AT-35.
䊳 INSPECTION END
TROUBLE DIAGNOSIS — BASIC INSPECTION
VG33E
Basic Inspection (Cont’d)
EC-707
FE
CL
MT
AT
TF
PD
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
GI
MA
EM
LC
Loading ...
Loading ...
Loading ...