Loading ...
Loading ...
Loading ...
SEF174Y
DTC Confirmation Procedure
=NGEC0604
CAUTION:
Be careful not to overheat engine.
NOTE:
If “DTC Confirmation Procedure” has been previously conducted,
always turn ignition switch OFF and wait at least 5 seconds before
conducting the next test.
With CONSULT-II
1) Turn ignition switch ON.
2) Select “DATA MONITOR” mode with CONSULT-II.
3) Check that “COOLAN TEMP/S” is above 10°C (50°F).
If it is above 10°C (50°F), the test result will be OK.
If it is below 10°C (50°F), go to following step.
4) Start engine and run it for 65 minutes at idle speed.
If “COOLAN TEMP/S” increases to more than 10°C (50°F)
within 65 minutes, stop engine because the test result will
be OK.
5) If 1st trip DTC is detected, go to “Diagnostic Procedure”,
EC-776.
With GST
Follow the procedure “With CONSULT-II”.
DTC P0125 ENGINE COOLANT TEMPERATURE SENSOR (ECTS)
VG33E
DTC Confirmation Procedure
EC-774
Loading ...
Loading ...
Loading ...