Loading ...
Loading ...
Loading ...
7 DETECT MALFUNCTIONING PART
Check the following.
쐌 Harness connectors E41, F25
쐌 Joint connector-1 (Refer to “HARNESS LAYOUT”, EL-254.)
쐌 Harness for open or short between harness connector E32 and Engine ground
䊳 Repair open circuit or short to power in harness or connectors.
8 CHECK CRANKSHAFT POSITION SENSOR (OBD)
1. Disconnect crankshaft position sensor (OBD) harness connector.
2. Loosen the fixing bolt of the sensor.
3. Remove the sensor.
4. Visually check the sensor for chipping.
SEF960N
5. Check resistance as shown in the figure.
SEF231W
Resistance: Approximately 512 - 632Ω [at 20°C (68°F)]
OK or NG
OK 䊳 GO TO 9.
NG 䊳 Replace crankshaft position sensor (OBD).
9 CHECK INTERMITTENT INCIDENT
Perform “TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT”, EC-142.
䊳 INSPECTION END
DTC P0335 CRANKSHAFT POSITION SENSOR (CKPS) (OBD)
KA24DE
Diagnostic Procedure (Cont’d)
EC-318
Loading ...
Loading ...
Loading ...