Loading ...
Loading ...
Loading ...
Fuel Cut Control (at no load & high engine
speed)
DESCRIPTION
NGEC0538
Input/Output Signal Chart
NGEC0538S01
Sensor Input Signal to ECM
ECM func-
tion
Actuator
Vehicle speed sensor Vehicle speed
Fuel cut
control
Injectors
Park/neutral position (PNP) switch Neutral position
Throttle position sensor Throttle position
Engine coolant temperature sensor Engine coolant temperature
Camshaft position sensor Engine speed
If the engine speed is above 2,500 rpm with no load (for example, in neutral and engine speed over 2,500
rpm) fuel will be cut off after some time. The exact time when the fuel is cut off varies based on engine speed.
Fuel cut will operate until the engine speed reaches 2,000 rpm, then fuel cut is cancelled.
NOTE:
This function is different from deceleration control listed under “Multiport Fuel Injection (MFI) System”, EC-615.
Evaporative Emission System
DESCRIPTION
NGEC0539
SEF569XA
The evaporative emission system is used to reduce hydrocarbons emitted into the atmosphere from the fuel
system. This reduction of hydrocarbons is accomplished by activated charcoals in the EVAP canister.
The fuel vapor in the sealed fuel tank is led into the EVAP canister which contains activated carbon and the
vapor is stored there when the engine is not operating or when refueling to the fuel tank.
The vapor in the EVAP canister is purged by the air through the purge line to the intake manifold when the
engine is operating. EVAP canister purge volume control solenoid valve is controlled by ECM. When the engine
operates, the flow rate of vapor controlled by EVAP canister purge volume control solenoid valve is propor-
tionally regulated as the air flow increases.
EVAP canister purge volume control solenoid valve also shuts off the vapor purge line during decelerating and
idling.
ENGINE AND EMISSION BASIC CONTROL SYSTEM
DESCRIPTION
VG33E
Fuel Cut Control (at no load & high engine speed)
EC-619
FE
CL
MT
AT
TF
PD
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
GI
MA
EM
LC
Loading ...
Loading ...
Loading ...