Loading ...
Loading ...
Loading ...
Remote control commands
R&S
®
MXO 4 Series
488User Manual 1335.5337.02 ─ 05
Parameters:
<Bandwidth> Range: 50 kHz
*RST: 50 kHz
Default unit: Hz
Usage: Asynchronous command
Manual operation: See "LF reject BW" on page 165
TRIGger:RFReject <Bandwidth>
Sets the limit frequency limit for the low-pass filter of the trigger signal. Frequencies
higher than this value are rejected, lower frequencies pass the filter.
Parameters:
<Bandwidth> Range: 1E+3 to 500E+6
Increment: 1000
*RST: 1E+6
Default unit: Hz
Usage: Asynchronous command
Manual operation: See "RF reject BW" on page 165
17.9.17 Actions on trigger
TRIGger:ACTions:OUT:STATe......................................................................................... 488
TRIGger:ACTions:OUT:DELay.........................................................................................488
TRIGger:ACTions:OUT:PLENgth..................................................................................... 489
TRIGger:ACTions:OUT:POLarity......................................................................................489
TRIGger:ACTions:OUT:STATe <State>
Activates the outgoing pulse on the [Trigger Out] connector on the rear panel.
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
Manual operation: See "Trigger out" on page 166
TRIGger:ACTions:OUT:DELay <Delay>
Defines the delay of the first pulse edge to the trigger point. The minimum delay is
600 ns.
Trigger
Loading ...
Loading ...
Loading ...