Loading ...
Loading ...
Loading ...
Measurements
R&S
®
MXO 4 Series
204User Manual 1335.5337.02 ─ 05
3. Tap on the measurements that you want to perform. You can scroll left and right
through the measurement list, to view all available measurements for the selected
"Category".
4. Select the source that you want to apply the measurement on.
5. If needed, click on "Setup" to configure further measurements.
The measurement results are displayed.
To configure measurements in the Measurement dialog
1. Select the waveform on the screen.
2. Press the [Measure] key.
The measurement for the selected waveform is enabled using the next available
measurement configuration. The measurement results are displayed.
To add a new measurement
1. Press the [Measure] key, to open the measurement dialog.
2. In the "Setup" tab, press "Add".
A dialog opens to select the measurements.
3. Select the "Source" for the measurement.
4. Select the "Category" of the measurement that you want to add, e.g. "Horizontal".
All available measurements for this category are displayed. For more details on the
available measurement types, see Chapter 9.2.4, "Measurement types",
on page 211.
5. Tap on a measurement from the list to enable it.
Selected measurements are marked with a blue check mark in their checkbox.
6. The measurements of some categories are listed on several tabs. To switch
between the tabs, press the points at the bottom of the list.
Automatic measurements
Loading ...
Loading ...
Loading ...